The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old December 12, 1999, 12:43 AM   #1
Senior Member
Join Date: October 29, 1999
Posts: 883
My 10/22T with V24 Weaver ran out of adjustment in the vertical.With vertical adjustment at max, bullet impact is still about 4" below bullseye. Is this unusual? My Banner 3x9 worked fine. Can it be the new scope. ( using Weaver T09 base) Should I shim the rings or base plate? Or get an adjustable mount? Any info. would be greatly appreciated.
skeeter is offline  
Old December 12, 1999, 09:18 PM   #2
4V50 Gary
Join Date: November 2, 1998
Location: Colorado
Posts: 19,343
If you shim anything, shim the base/receiver and not the rings. The rings you want as steady as possible and any wobble will throw off the scope after each successive shot. I use aluminum cut from a soda/beer can. You may want to expoxy or acraglass it too as this prevents moisture or dirt from building up between the shim, receiver and base.

Vigilantibus et non dormientibus jura subveniunt

4V50 Gary is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:02 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04510 seconds with 9 queries