The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old July 25, 1999, 04:46 PM   #1
Join Date: July 3, 1999
Posts: 93
I have a TA-90, similar to a Witness but with a slide mounted safety(ala Beretta 92F). If I pull the trigger in double action mode (dry firing) the hammer falls like it should, but if I slightly pull the trigger to either side while pulling back on the trigger, the hammer drops to the half cock position. I have never had this happen to me at the range, but it just doesn't seem right. Is something worn out?
mattfra is offline  
Old July 26, 1999, 07:15 AM   #2
George Stringer
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Something could be worn out. It sounds like a sear/sear spring problem. I think it would be worth a trip to your local smith. George
George Stringer is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:38 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05629 seconds with 9 queries