The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old March 19, 2005, 06:23 PM   #1
Join Date: September 24, 2002
Location: SW Kansas
Posts: 41
Primer Question

Is the Winchester large psitol primer a "hotter" primer than the Federal 150 and therefore more suitable for a slower powder if there's choice between the two?

Thank you.
Primered is offline  
Old March 20, 2005, 12:32 AM   #2
Senior Member
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,270

I don't know.
Could be.

Difficult to say; each lot can vary.

Federal's have been know to ignite same-load charges to slightly higher pressure; measured.
That said, what IS suitable is a primer that is called for by data, one that ignites reliably, and after it's ignited ignites the powder charge, regardless of temperature or position.

That any help?
"all my ammo is mostly retired factory ammo"
WESHOOT2 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:57 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2016 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.08858 seconds with 9 queries