The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old June 22, 2002, 02:32 PM   #1
Senior Member
Join Date: December 5, 1999
Location: Seattle, Washington, USA
Posts: 1,686
Dillon 550 and AA2200 Powder?

Started loading some 223 rem on my Dillon 550 with some military surplus powder, AA2200, and noticed some light powder spillage on the shellplate.

Made sure verything was right.

Called Dillon and they stated that some extra fine powders may spill out of their setup. Say it in the manual as well. Small extruded powders may spill.

How do you deal with this because 100 rounds an our on my Lyman turret press isn't fast enough.

I know I can do an easy 250-300 an hour on the Dillon 550.

Just clean off the excess powder every 50 rounds?

What do you do?
The Seattle SharpShooter - TFL/GT/AR15/SGT/PCT/KTOG/SWF/RF/HKPRO/OA2/1911Forum
Reloaded .223 Rem, 9mm, 40SW, 357 SIG, 10mm, 44 Spl, 44 Mag, 45 ACP Today?
jtduncan is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:00 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2017 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.03998 seconds with 9 queries