Quote:
...would allow the case to be pushed up farther into the die yes? and would that not allow the case to be sized a bit farther down?
|
Yes, but you're going to use either the rifle's chamber or a gauge to set up the resizing die (right?), so just don't adjust it that far...
If you want to read more about this, here's one
http://thefiringline.com/forums/show...ght=case+gauge
If you do create "induced excess headspace" by over-resizing, you can quickly get into case head separations.
One of the worst instructions I've ever read for setting up a resizing die go essentially like this -
"Adjust die until it touches the shell holder, then lower the ram and turn CW another 1/4 turn. Lock the die."
That 1/4 turn is around 0.018", and the difference between GO and NOGO headspace is usually around 0.006".
Those who believe they can set up a resizing die without using
something as a gauge are being extremely optimistic.