View Single Post
Old February 23, 2013, 05:23 PM   #19
dahermit
Senior Member
 
Join Date: October 28, 2006
Location: South Central Michigan...near
Posts: 6,501
Quote:
Im thinking of fileing them down, wont take much to do just wondered if anyone else on here had the same problem.
I have heared uf win having thick rims but never heared of being to big in diameter.
I have had both. When a case will not fit into the shell holder, I put layout dye on it and try it again. The layout dye will indicate what the problem is. I have had Winchester rims so thick, that when I draw-filed them, almost all the head stamp was gone. I have also had the rims too large in diameter to fit into the shell holder and a little careful turning gets them the correct diameter. When I buy 100 count bag of brass and three or so will not fit, I hate to end up with an odd-number (less than 100), lot, so I "correct" them.
dahermit is offline  
 
Page generated in 0.03538 seconds with 8 queries