View Single Post
Old February 4, 2013, 12:40 PM   #4
rclark
Senior Member
 
Join Date: February 12, 2009
Location: Butte, MT
Posts: 2,619
1) Do you 'need' a Belt Mountain Base pin (running into problems with the base pin jumping)? Or just want one.... At any rate. I don't use the allen screw at all. I just leave it be on my #5 base pins. No need to to 'drill' anything. Also you have a 3 3/4 in barrel. First the pin is just a New Vaquero (medium frame) base pin. BUT, with the short barrel, you need a 'small' head on the base pin to allow the ejector rod to properly eject the shells. You shouldn't use therefore a #5 base pin for the shorty. Hope that kind of makes since! Kyle will sell you the right one if you ask .

2) I personally just clean my guns with Hoppes #9 and that is that (blued and SS) Sometimes I'll lightly oil the gun if put away for a few months. Not a big deal here. Never have seen any 'rusting'.

3) First thing I do is break my Rugers all the way down and thoroughly clean them. Then oil and good to go.

4) Never happen. You are good for several life times of shooting. Just go shoot it and enjoy.
__________________
A clinger and deplorable, MAGA, and life NRA member. When guns are outlawed, only outlaws will have guns. Single Action .45 Colt (Sometimes colloquially referred to by its alias as the .45 'Long' Colt or .45LC). Don't leave home without it. That said, the .44Spec is right up their too... but the .45 Colt is still the king.

Last edited by rclark; February 4, 2013 at 12:45 PM.
rclark is offline  
 
Page generated in 0.03419 seconds with 8 queries