Thread: The Best Dremel
View Single Post
Old March 12, 2021, 05:40 AM   #19
Senior Member
Join Date: March 20, 2011
Location: Willamina, OR
Posts: 1,652
Back when I was porting 2 stroke cycle engines, I had access to some pretty nice equipment like you mention. That was a long time ago and I never could afford to buy stuff like that for my own use.

The rotary tools I use now are use for much less precise work but it's something I do often and I've been happy with how the Dremel is holding up so far.

I might sill take that Harbor Fright 1/4" die grinder apart and replace the bearings. It makes the sounds of skipping bearings and since I'm not thrilled with it as is, I have little to loose. I'll look into a Makita die grinder. I have other Makita tools that I'm very happy with.

Geezerbiker is offline  
Page generated in 0.04721 seconds with 8 queries