The Firing Line Forums - View Single Post - Scope Mounting Question

MikeSD · January 3, 2013, 12:17 AM

I used a torque driver to tighten the screws. I set the driver at a little under 20 in-lbs of torque, on the ring halves. I think I'm ok there. But good to know I'm worrying about nothing on the ring spacing.

When I get the new base, I'll move the scope back about 1". I'll just have enough room to avoid the ejection port.

January 3, 2013, 12:17 AM	#5
MikeSD Junior Member Join Date: January 2, 2013 Posts: 5	I used a torque driver to tighten the screws. I set the driver at a little under 20 in-lbs of torque, on the ring halves. I think I'm ok there. But good to know I'm worrying about nothing on the ring spacing. When I get the new base, I'll move the scope back about 1". I'll just have enough room to avoid the ejection port.