Thread: Copper removal?
View Single Post
Old January 12, 2019, 08:38 PM   #27
zeke
Senior Member
 
Join Date: November 17, 1999
Location: NW Wi
Posts: 829
My bottles say KG 12 big bore. I use hoppes and repeatedly scrub out he bore, than run tight dry patch through. Then a tight patch with kg 12 on it, using the instructions. If the patch comes out heavy, run another tight patch with kg 12. Then a nylon brush with kg 12, then patch over jag with kg 12. Then a dry patch and then clean out bore with hoppes. I clean off all the tools/rods with warm soapy water.

Am not about to try all the copper cleaners available, but the only copper cleaner i have tried that came close was cr 10 (Think barnes used to make it)

Last edited by zeke; January 12, 2019 at 09:06 PM.
zeke is offline  
 
Page generated in 0.02810 seconds with 8 queries