View Single Post
Old January 10, 2019, 10:37 AM   #4
FoghornLeghorn
Senior Member
 
Join Date: September 2, 2011
Posts: 678
Thanks for the above. My digital torque wrench is a half inch drive and probably impractical for driving a #8 machine screw.

I've always used the typical allen wrench to mount scopes. I tighten them to hand tightness to where the 'L' shaped "wrench" flexes a little bit. Tight enough to where it's uncomfortable to go beyond that point.

I've not had any problems, and I never used a thread locker. Back in the day, I've used fingernail polish, but I don't remember how that turned out.

So, I'll use the blue. I know I don't want to use red as I might swap out the system at some point.

thanks again
__________________
"I say, boy, I say, you're doing a lot of choppin', but no chips are flyin'."
FoghornLeghorn is offline  
 
Page generated in 0.03019 seconds with 8 queries