View Single Post
Old November 13, 2009, 09:43 PM   #4
[email protected]
Senior Member
 
Join Date: August 21, 2008
Location: Kansas City
Posts: 1,393
No I don't have any metel working stuff. I used to work in a tool&die shop
many years ago so have some experence. I just drilled & tapped the hole in
the back of the trigger guard for a 10-32 set screw. The trigger shoe is held
in place with two small allen set screws. The champering was done with a
45 degree champering tool by hand. It's just a small champer, just enough
to keep from shaving lead. The ball is almost flush with the end of the cyclinder after loading due to the "Cream-of-Wheat" filler so it doesen't have
to jump too far to engage the forcing cone & rifiling.
kwhi43@kc.rr.com is offline  
 
Page generated in 0.03882 seconds with 8 queries