View Single Post
Old April 14, 2018, 09:50 PM   #9
dahermit
Senior Member
 
Join Date: October 28, 2006
Location: South Central Michigan...near
Posts: 5,416
In the late sixties, I had a .44 magnum Blackhawk (pre-SuperBlackhawk). The problem I had was the ejector housing screw was screwed-in to a threaded sleeve that was press-fit into the barrel. That sleeve would loosen and come out with the screw. After the local gunsmith trying soft solder (to maintain the Bluing), it again came loose and I finally had him Silver Solder it in place (messing up the Bluing). It never came loose again but if I understand correctly, the later models had a screw that was threaded into the barrel itself...no sleeve.
dahermit is offline  
 
Page generated in 0.02934 seconds with 8 queries