View Single Post
Old September 11, 2012, 11:50 PM   #7
timelinex
Senior Member
 
Join Date: March 6, 2011
Posts: 231
Is there a reason you are trying to get your bore clean down to bare metal? If you ask me, they did you a favor by filling in the imperfections a little with copper. Now you have to waste your own ammunition doing it all over again.

On a side note, get some Wipe-out. You spray the foam in there, leave it for a half hour and then wipe it out. If you want it down to bare metal just do this twice and your done.
timelinex is offline  
 
Page generated in 0.03414 seconds with 8 queries