View Single Post
Old January 25, 2013, 01:26 AM   #2
Bill DeShivs
Senior Member
 
Join Date: April 7, 2006
Posts: 10,966
You can probably do it, but it's not necessary.
Get a can of brake parts cleaner and just blow all the old oil and crud out of the inside. Then, spray the same areas with WD 40 to get lubrication and protection into the gun's nether regions, as the brake cleaner will remove all the oil from inside the gun. Be very careful not to get this stuff in your eyes, and rubber gloves are recommended. Dry the gun thoroughly, and use a good oil like Quick Release on/in the gun.
__________________
Bill DeShivs, Master Cutler
www.billdeshivs.com
Bill DeShivs is offline  
 
Page generated in 0.02223 seconds with 8 queries