View Single Post
Old June 20, 2002, 09:13 PM   #5
Edward429451
Junior member
 
Join Date: November 12, 2000
Location: Colorado Springs, Colorado
Posts: 9,494
Are all taurus guns so loose? I looked at a used 431 .44 special yesterday and it was loose as a goose. Figured it had been shot to death but now I'm not so sure.

I've been taught to check for lockup tightness by cocking the hammer, pulling the trigger and let it down past release notch only slightly, not hammer full forward, then continue holding trigger to rear and try to wiggle cylinder back n forth...

Am I doing it right?
Edward429451 is offline  
 
Page generated in 0.01963 seconds with 8 queries