View Single Post
Old August 29, 2020, 12:00 AM   #11
BJung
Senior Member
 
Join Date: December 5, 2019
Posts: 768
I'm going to think outside the box and get everyone's opinion. If I had a lot of bullets like this, decided to shoot them, yet was worried about leading, how about shaking them up in some Lee Alox? Or, mix some PC with Acetone, paint the one spot, and bake the bullets.

To me, the idea of baking the bullets is to open the lead molecules and allowing the paint to melt between the lead molecules slightly. That's why when you hammer the lead bullets, the paint doesn't chip off. In the past, this was the theory for leading auto body parts.
BJung is offline  
 
Page generated in 0.03000 seconds with 8 queries