View Single Post
Old January 24, 2010, 06:59 AM   #3
TenRing
Senior Member
 
Join Date: December 1, 2009
Posts: 427
I figured by buying a 3" barrel, it would already have the front sight milled in. I have found new barrels for about $65 and by the time I recrowned the cut barrel, bought a front sight, drilled and pinned it, I would have at least that much into the materials.

On the other hand, if I cut the barrel down, do I need to be careful to make the cut at a particular point on the rifling or doesn't that matter?
TenRing is offline  
 
Page generated in 0.03636 seconds with 8 queries