View Single Post
Old August 18, 2022, 11:04 AM   #3
Senior Member
Join Date: February 16, 2006
Location: IOWA
Posts: 8,609
Dremel with cutting disc

I will need to cut the new spring to the same length as the stock spring. What is the best tool for the job?
Well, this project could go sideways for you but if you have this figured out then that's fine.. ...

Not worth damaging a "good" set of dykes. So my suggestion, is using a Dremel with that thin brown, cutting "disc", just go slow and match the proper maintain the proper angle. .....

Be Safe !!!
'Fundamental truths' are easy to recognize because they are verified daily through simple observation and thus, require no testing.
Pahoo is offline  
Page generated in 0.03845 seconds with 8 queries