View Single Post
Old July 3, 2022, 10:47 AM   #7
Jim Watson
Senior Member
Join Date: October 25, 2001
Location: Alabama
Posts: 17,847
The only neckdown I have done was .45-70 to .33 WCF and .40-65. No problems if done in easy stages. I would hope .30 to 7mm no worse.


I once accidentally ran a 45 Auto case into a 44 Special/Mag carbide sizing die. I didn't even notice by the feel that I had done this, so it was quite a surprise when I lowered the ram to see my new wildcat case sitting in the shell holder.
There was once some interest in cheap .44 plinkers made this way.
Jim Watson is offline  
Page generated in 0.03492 seconds with 8 queries