View Single Post
Old December 23, 2019, 11:35 PM   #2
rock185
Senior Member
 
Join Date: September 2, 2001
Location: Out West in Rim Country
Posts: 914
Hello and welcome Holmes. The area of the firing pin hole was damaged on my MK VI. I had to keep looking for a while. Gunpartscorp had one, but when I got it it was evident that someone had already tried to repair the same problem by brazing. That would not have been durable. Gunparts refunded my money without any problem. I kept looking, and at some point located a good one at Jack First, IIRC. So were I still looking for a recoil shield, I would keep doing what I did; checking, Numrich, Jack First, Gunbroker, Ebay, and anywhere else I could think of. When some of these obsolete parts pop up, there may be only one available, so if you're not regularly checking, you may miss it. Good luck in your search.
__________________
COTEP 640, NRA Life
rock185 is offline  
 
Page generated in 0.03434 seconds with 8 queries