The Firing Line Forums - View Single Post

nigsbro · March 12, 2013, 05:36 PM

Hi I know its alot to ask but over here in the uk there isnt anyone I can ask. could someone please take some messurements for me in iches or mm off their auto-mate please? as been looking around now for weeks with no luck,
the messurements I need are below.

depth
slope size,
front hight up to slope
rear hight
disk size aross disk
center of the disk to the conecting arm bolt size
lenght of arm from disk bolt to upper bolt thats on the rear of the press
and thickness of steel used for the auto mate and the disk.

If someone could do this for me it would be a great help as im trying to build a 12 volt unit as in the uk mains power is 240 volts.

Cheers Bart.

March 12, 2013, 05:36 PM	#1
nigsbro Junior Member Join Date: March 12, 2013 Posts: 2	mec automate users help please Hi I know its alot to ask but over here in the uk there isnt anyone I can ask. could someone please take some messurements for me in iches or mm off their auto-mate please? as been looking around now for weeks with no luck, the messurements I need are below. depth slope size, front hight up to slope rear hight disk size aross disk center of the disk to the conecting arm bolt size lenght of arm from disk bolt to upper bolt thats on the rear of the press and thickness of steel used for the auto mate and the disk. If someone could do this for me it would be a great help as im trying to build a 12 volt unit as in the uk mains power is 240 volts. Cheers Bart.