View Single Post
Old September 23, 2001, 10:25 PM   #3
fortunate Son
Junior Member
Join Date: July 6, 2001
Location: North Carolina
Posts: 3
The pistol is clean and the pin moves back and forth along the bore axis. When I "shake" the pin forward, it protrudes approximately 1/16" from the breach surface. When I shake it back it is recessed into the breach. Another thread response I received at glocktalk says this is the way it is with a Mak. Doesn't make sense to me.
Cole's Axiom: The sum of the intelligence on the planet is a constant. The population is growing.
fortunate Son is offline  
Page generated in 0.03284 seconds with 8 queries