The Firing Line Forums - View Single Post

INGunGuy · January 1, 2009, 10:30 PM

I appreciate all the information on case prep. Yea I was reading that older thread about trimming and chamfering the cases. From what I can tell, I can get multiple heads so I am not having to adjust my different dies for changing calibers. I just need something that is going to decrease the amount of time I spend reloading. It does seem like 1500-2000 is going to take a while to pay for itself in cost savings over commercial ammo. As for accuracy, like I said my old single stage will do me just fine, but since I am trying to load 4000+ pieces of brass a month, something that can handle all the pistol and some rifle ammo is what I am looking for.

INGunGuy

January 1, 2009, 10:30 PM	#4
INGunGuy Senior Member Join Date: November 11, 2008 Location: Jeffersonville, Indiana Posts: 142	I appreciate all the information on case prep. Yea I was reading that older thread about trimming and chamfering the cases. From what I can tell, I can get multiple heads so I am not having to adjust my different dies for changing calibers. I just need something that is going to decrease the amount of time I spend reloading. It does seem like 1500-2000 is going to take a while to pay for itself in cost savings over commercial ammo. As for accuracy, like I said my old single stage will do me just fine, but since I am trying to load 4000+ pieces of brass a month, something that can handle all the pistol and some rifle ammo is what I am looking for. INGunGuy __________________ Governments are instituted among men, deriving their just powers from the consent of the governed. That whenever any form of government becomes destructive of these ends, it is the right of the people to alter or abolish it, and to institute new government.