View Single Post
Old June 12, 2011, 12:54 PM   #7
Senior Member
Join Date: January 20, 2001
Location: UCLA (upper corner of lower Alabama)
Posts: 521
I've got a Lee 4 hole turret too. My practice is to decap the brass and then tumble. Next step is to use the hand primer to prime the clean casings. I prime as an extra step because putting the primers in the Lee attachment, with these big old hands, is a pain in the tookus.

To extend the media life, I use about a third of a dryer softener sheet, also cut into thirds, in each batch. This picks up quite a bit of the residue from tumbling and greatly extends the life of the media (I use the corn cob mix).

Hope this helps.
Arub is offline  
Page generated in 0.03509 seconds with 8 queries