help with case crimping
Hey now, that sounds logical. The 50AE cases are not widely produced by many manufacturers(speer,IMI,starline)so I don't have many variables to test. However I checked the two brands which I personally bought and once-fired. It seems that the case walls are consistantly thinner by an average of .001-.002 of an inch on the nickel cases. This would mean a total of .002-.004 less inner diameter while still retaining the common outside diameter (.530)I was crimping with the brass cases. I'm not sure, but I guess that could make the difference. Has anyone else experienced this with loading nickel cases vs. brass? I wonder if this theory is true, why it is done? Thank you doctor j, you may have just answered my $64,000 question!
|