The Firing Line Forums - View Single Post - Colt-Walker Cylinder Jam

sfhurst · June 23, 2009, 01:20 PM

I have a Colt-Walker .44 sold by Colt, but built for them by Uberti. VERY high quality, but if I correctly tighten the wedge that binds the barrel to the receiver group the cylinder will not turn, i.e. tightening the wedge forces the barrel back against the front of the cylinder eliminating the very small gap.

Help. Any others experiencing this problem? Any solutions?

June 23, 2009, 01:20 PM	#1
sfhurst Junior Member Join Date: June 23, 2009 Posts: 2	Colt-Walker Cylinder Jam I have a Colt-Walker .44 sold by Colt, but built for them by Uberti. VERY high quality, but if I correctly tighten the wedge that binds the barrel to the receiver group the cylinder will not turn, i.e. tightening the wedge forces the barrel back against the front of the cylinder eliminating the very small gap. Help. Any others experiencing this problem? Any solutions?