View Single Post
Old October 5, 2007, 01:16 PM   #4
JohnKSa
Staff
 
Join Date: February 12, 2001
Location: DFW Area
Posts: 24,930
For steel on steel sliding contact, a thin moly based grease is about as good as it gets. Moly should never be used on rolling surfaces.

For sliding contact where one or both surfaces are not steel, any light grease is good, I typically use white lithium grease for steel on aluminum contact.
__________________
Do you know about the TEXAS State Rifle Association?
JohnKSa is offline  
 
Page generated in 0.03110 seconds with 8 queries