View Single Post
Old November 25, 2012, 08:13 PM   #3
stevenrs1
Junior Member
 
Join Date: May 7, 2009
Location: Southern California
Posts: 6
Thanks for the answer. The stud I bought from Numrich fits very loosely in the locking block. In the last post I said it fit snuly but I had it in backwards and could not assemble it as clearances were off. It fits loosely (actually sloppy) the right way and once the locking block is assembled in the carrier it cannot fall out due to tight clearance. The gun seems to lock fine and I test fired 3 primers ok. I am still a little skeptical though.
stevenrs1 is offline  
 
Page generated in 0.02587 seconds with 8 queries