View Single Post
Old January 16, 2020, 06:51 PM   #5
Deltadart
Senior Member
 
Join Date: April 26, 2015
Location: Washington State
Posts: 151
Hi Scorch
I just received the replacement sight from Marbles. Since this is a ramp, I needed a sight pusher to remove and replace the sight so I ordered a Williams sight pusher but have not gotten that yet. Just looking at it all, you might be right about leaving the hood on the ramp. I also found a Sako hood that may fit if the original does not work. I know most don't like the hood, but I am used to it so I would like to keep it up there if possible.
Thanks
Paul
Deltadart is offline  
 
Page generated in 0.02801 seconds with 8 queries