View Single Post
Old June 22, 2019, 10:13 PM   #9
Senior Member
Join Date: April 24, 2010
Location: Ohio
Posts: 581
Likely what you are running into is the increased arbor diameter that Uberti uses instead of making the arbor the correct length to bottom out in the barrel lug. If you check with a micrometer you will find that the arbor diameter increases by a couple of thousandths at the point where the barrel is about to seat on the frame pins. This is a poor substitute for a correct length arbor and only works for a short period as removing the barrel for cleaning and seating the wedge will wallow out the arbor hole so it slips over the increased diameter.
denster is offline  
Page generated in 0.03204 seconds with 8 queries