Thread: Gonic Arms
View Single Post
Old September 27, 2011, 10:56 PM   #9
arcticap
Senior Member
 
Join Date: March 15, 2005
Location: Central Connecticut
Posts: 3,166
Perhaps a sizing die will work to turn conventional bullets into the proper size. That would require carefully measuring and/or slugging the bore.

This reputable casting outfit makes custom sized conicals:

http://bullshop.gunloads.com/

Harvester makes crush rib .54 sabots that reduce loading friction by up to 50%.

http://www.harvestermuzzleloading.co...hk=1&Itemid=18

Some folks polish or lap the bores of their guns with bore paste and/or polishing compounds when they're too tight. That can help to effectively ease the loading difficulty.

This individual below offers custom .50 Gonic Bullets, and maybe he's also familiar with the requirements for the Gonic .54's and how to best acquire the proper fitting bullets for it.

http://www.nodakoutdoors.com/forums/...p?f=97&t=85817

Quote:
Gonic Bullets

by jim_greene13778 ยป Wed Sep 22, 2010 10:07 pm


I just wanted to let people know that I'm looking for a nice Gonic 50 cal rifle. I also want people to know that I have and am making bullets for the Gonic 50 cal rifles. They meet exact specs. set by Mr Rodney himself. Prices will vary depending on amount purchased, so call for pricein - I do have various grains also. I hope this helps everyone that loves the Gonic rifles as much as I do and fills the need for good amunition. You can email me at [email protected] - Thanks . . . . . . . . Jim.

Last edited by arcticap; September 27, 2011 at 11:30 PM.
arcticap is offline  
 
Page generated in 0.04554 seconds with 8 queries