Thread: bullet puller ?
View Single Post
Old May 11, 2012, 08:02 PM   #14
603Country
Senior Member
 
Join Date: January 6, 2011
Location: Thornton, Texas
Posts: 3,998
I've never had any problem with bullet damage with my hammer-type kinetic puller. I've used it a lot, and like I said earlier, if you put some wadded paper towel in the 'collecting' end, there's no obvious bullet damage at all. I've reloaded and shot pulled bullets time and again and I can't see any accuracy loss. Admittedly, if I was shooting 4 inch groups, I'd never see any accuracy loss, but I do shoot a bit better than that.

If I was going to pull 250 bullets and I was in a hurry and had no plans to reuse the bullets, I'd go with pliers and my press. Much faster.
603Country is offline  
 
Page generated in 0.02460 seconds with 8 queries