View Single Post
Old October 13, 2011, 06:20 PM   #5
Smokymtnsmoke
Junior Member
 
Join Date: January 19, 2010
Posts: 5
Jim, glad to give you a chuckle but your press must run a bit smoother or has less tolerance than mine as the PLASTIC square ratchet wears after only a thousand or so rounds. It is visibly wallowed out and miss shaped. Why does it do this? I don't know except that it must take more force on the lever to actuate the rotating turret of my press than it does on yours causing excessive wear on that PLASTIC. Got any REAL solutions? as I'm all ears.

I'm more aimed at adding a bullet drop tube with a bullet feeder die such as the RCBS. I load mostly jacketed or copper plated bullets so that should work ok but I was hoping someone here had climed that mountain and could tell me of their experiences with that challenge.

Watch this video and you will see what I'm after...

http://youtu.be/O5mP4P7hOSU
Smokymtnsmoke is offline  
 
Page generated in 0.03711 seconds with 8 queries