View Single Post
Old June 20, 2011, 04:37 PM   #12
serf 'rett
Senior Member
 
Join Date: June 25, 2009
Location: Stuttgart, AR
Posts: 1,569
Do you need to lube with carbide pistol dies? I don't think so; however, it does make sizing a little easier and I like "easier." I keep a can of the Imperial Wax on the bench where I can touch it with a couple of fingers whenever I start to feel greater resistance during sizing. The small amount of wax on my fingers is not messy and I've developed the habit of rolling the brass a little between my fingers as I put it in the press. Works for me on my small volume runs.
__________________
A lack of planning on your part does not necessarily constitute an emergency on my part.
serf 'rett is offline  
 
Page generated in 0.03395 seconds with 8 queries