|
Have you measured the inside dia of the 45 cases? If it is .451 and you can crimp just past halfway of the dia of the ball it should be fine. If not .451 inside Dia you will deform the ball somewhat. I tried this with 44 Rem mag brass with a turned down rim to fit my 44 Rem. conversion cylinder. and they work OK, but the ball is deformed in the case side upon seating. Not near as accurate as the .451 x 248 grn bullet for the 44 Rem Round. I did use some at a cowboy action target. Target was big and I was close so I didn't aim, just pointed and fired. Hit it. I used some at a 25 yd. official pistol and rapid fire targettarget They seem to shoot a bit high and to the left, but that was in the pistol that had the indentations in the rifling under the front sight and above the rammer latch. Everything was high and left that morning so i honestly cannot tell you if they are are aren't accurate.
|