The Firing Line Forums - View Single Post

Beagle333 · February 2, 2019, 10:51 PM

I just got this one on Monday. It was a Group Buy from MiHec and I was really excited for it to arrive.
I put it together this morning and I loaded just the shallow HP pins to begin with. It comes with shallow, deep, penta and solid point pin sets.

Then I ran it through three heat cycles in my makeshift mold oven. The display actually was at 415° but I snapped the pic just as it was changing to another number and it didn't show up in the pic.

Then I loaded up the Pro Melt with a bunch of my HP ingots and set it for 720°.

And after that melted, I fluxed it a little with some sawdust and a chunk of a red candle.

February 2, 2019, 10:51 PM	#1
Beagle333 Senior Member Join Date: January 7, 2012 Location: Auburn, AL. Posts: 2,332	The MP 432 Hammer I just got this one on Monday. It was a Group Buy from MiHec and I was really excited for it to arrive. I put it together this morning and I loaded just the shallow HP pins to begin with. It comes with shallow, deep, penta and solid point pin sets. Then I ran it through three heat cycles in my makeshift mold oven. The display actually was at 415° but I snapped the pic just as it was changing to another number and it didn't show up in the pic. Then I loaded up the Pro Melt with a bunch of my HP ingots and set it for 720°. And after that melted, I fluxed it a little with some sawdust and a chunk of a red candle. __________________ . . . Have a Colt and a smile.