The Firing Line Forums - View Single Post

T. O'Heir · November 13, 2017, 02:33 PM

Cases getting stuck in the sizer die are usually caused by insufficient lube on the case. It should not happen with carbide dies though.
Like jdc606 says, there shouldn't be any need for lube in the expander/charger die. The case shouldn't be touching the sides of the die. You sure it's the right die?
Shouldn't be any need for car polish in the tumbler either.

November 13, 2017, 02:33 PM	#5
T. O'Heir Senior Member Join Date: February 13, 2002 Location: Canada Posts: 12,453	Cases getting stuck in the sizer die are usually caused by insufficient lube on the case. It should not happen with carbide dies though. Like jdc606 says, there shouldn't be any need for lube in the expander/charger die. The case shouldn't be touching the sides of the die. You sure it's the right die? Shouldn't be any need for car polish in the tumbler either. __________________ Spelling and grammar count!