Too Many variables to say , you do this & that cut& dried !!!!can`t say!!!!
I anneal in low lite , put the low flame on the shoulder while turnin in a cordless drill .
Next I look for a very slight glow of the shoulder neck area then quench in cold water.
I suggest not gettin em to glow at first just do a 123 count at first .
I also feel it`s very important to get the temp the same all the way around the case , hence the cordless drill .
I would suggest tryin 5 cases then perpare em & load & shoot em a couple of times & see if they react to annealling & affect accuracy in a positive way !!
It`s kinda like handloading & casting bullets , ya gotta start somewhere !
I hope this helps even if a little