View Single Post
Old November 17, 2012, 05:49 PM   #7
4V50 Gary
Join Date: November 2, 1998
Location: Colorado
Posts: 20,113
If you're checking headspace by examining fired cases, you're not doing it right.

Remove the extractor from the bolt and insert a "go" gauge into the action. It should close.

Now try the same with the "no go" gauge. If it closes, it's probably over SAAMI specs.

If it closes on a "field" gauge, the barrel shank must be shortened to reduce the headspace and that means lathe time by the gunsmith.
Vigilantibus et non dormientibus jura subveniunt. Molon Labe!
4V50 Gary is online now  
Page generated in 0.04864 seconds with 8 queries