The Firing Line Forums - View Single Post

wncg180 · September 21, 2010, 04:37 PM

I am a new member to this site, so I do not know if this was asked in a previous thread, but here it goes...

I own a Remington 870 that I am in the process of switching out the stock and forend. Now the problem I am having is putting the fore end nut back on after putting on the new forend...can't seem to get that bugger to line up the threads..and damn fine threads they are...any suggestions on how to remedy this problem?

September 21, 2010, 04:37 PM	#1
wncg180 Junior Member Join Date: September 21, 2010 Posts: 2	Another Remington 870 Problem I am a new member to this site, so I do not know if this was asked in a previous thread, but here it goes... I own a Remington 870 that I am in the process of switching out the stock and forend. Now the problem I am having is putting the fore end nut back on after putting on the new forend...can't seem to get that bugger to line up the threads..and damn fine threads they are...any suggestions on how to remedy this problem?