View Single Post
Old December 11, 2019, 01:27 PM   #6
SGW Gunsmith
Senior Member
Join Date: December 31, 2014
Location: Northwest Wisconsin
Posts: 276
There's no reason why you can't use an impact wrench as long as you use a well fitting hollow ground driver bit. Just don't use a 10 pound sledge hammer. Tapping lightly on the top end of the impact driver while you turn it should do the trick. And, if you have any "Kroil" handy, try a few drops of that around the screw head before applying the impact wrench.
Brownells will have the perfect size driver bit that you need for around $4.00.
SGW Gunsmith is offline  
Page generated in 0.02975 seconds with 8 queries