The Firing Line Forums - View Single Post - Trimming 308

Powderman · September 8, 2012, 09:51 PM

Using .308 as an example, I load new cases and fire once, as is. Same, of course, for factory new ammo.

During the first reloading process, I trim to the minimum length (2.000). I'll then shoot the lot and measure until I have to trim again. When I have to trim again, I'll reload and shoot once afterward, then the case gets scrapped.

I usually average 5-6 reloadings of fired cases after the first trim.

September 8, 2012, 09:51 PM	#6
Powderman Senior Member Join Date: September 7, 2001 Location: Washington State Posts: 2,166	Using .308 as an example, I load new cases and fire once, as is. Same, of course, for factory new ammo. During the first reloading process, I trim to the minimum length (2.000). I'll then shoot the lot and measure until I have to trim again. When I have to trim again, I'll reload and shoot once afterward, then the case gets scrapped. I usually average 5-6 reloadings of fired cases after the first trim. __________________ Hiding in plain sight...