View Single Post
Old June 22, 2012, 11:24 AM   #1
Prof Young
Senior Member
 
Join Date: August 22, 2007
Location: Illinois - down state
Posts: 2,514
Lee Perfect Powder Measure

Loaders:

So, I'm learning to use my Lee Prefect Powder measure and pretty much like it a lot. I did the "break in" thing according to the instructions where you run a powder through it to get it "lubricated." Now it seems like the first five or so loads get progressively lighter. I'll start at 7.4 grains and five loads later it is down to 7.1. So I re adjust and it stays pretty consistent for the remainder. I'm checking the weight every five or ten loads. Anybody else run into this?

Live well, be safe
Prof Young
Prof Young is offline  
 
Page generated in 0.02923 seconds with 8 queries