View Single Post
Old September 12, 2012, 06:05 AM   #14
jwrowland77
Senior Member
 
Join Date: March 23, 2012
Location: Conway, Arkansas
Posts: 1,397
Quote:
Originally Posted by hooligan1 View Post
Oh well, some of those loads in that website are different than that from the manual, I try to go by what the bullet maker go's by because their testing facilities are better than ours.
That's kind of what I was taught, which is what was causing me a little confusion/frustration because ql was saying that the load that shot good was around the 80% case fill mark which could cause in misfire if the powder is not against the primer. Maybe not misfire but the powder not burning the way it was intended.
jwrowland77 is offline  
 
Page generated in 0.06845 seconds with 8 queries