The Firing Line Forums - View Single Post

FrankenMauser · April 10, 2011, 01:06 PM

Nosler and Swift run their bullets through Juenke Bullet Machines for tolerance checking. They are some of the most dimensionally precise bullets you can find.

Swift used to state that their machine was set to reject any critical dimension that deviated by more than 0.0003", but I haven't seen that statement lately.

Whatever the tolerances are; Swift and Nosler bullets impress me more than anything else, when it comes to consistency. There is a reason those two companies sell more "perfectly good" factory seconds, than anyone else. They may still be good bullets, but the Juenke machine rejected them for some reason.

April 10, 2011, 01:06 PM	#17
FrankenMauser Senior Member Join Date: August 25, 2008 Location: In the valley above the plain Posts: 13,424	Nosler and Swift run their bullets through Juenke Bullet Machines for tolerance checking. They are some of the most dimensionally precise bullets you can find. Swift used to state that their machine was set to reject any critical dimension that deviated by more than 0.0003", but I haven't seen that statement lately. Whatever the tolerances are; Swift and Nosler bullets impress me more than anything else, when it comes to consistency. There is a reason those two companies sell more "perfectly good" factory seconds, than anyone else. They may still be good bullets, but the Juenke machine rejected them for some reason. __________________ Don't even try it. It's even worse than the internet would lead you to believe.