The Firing Line Forums - View Single Post

Lilswede1 · December 5, 2009, 11:55 AM

I use the RCBS electric case prepping machine that has 5 rotating stations.
One for deburring outside and one for deburring the inside. I have noticed that this will leave more of and "edge" on the case then if I do it by hand.
This is only on the very edge of the case neck.
Could this b causing the splits?

December 5, 2009, 11:55 AM	#5
Lilswede1 Senior Member Join Date: September 8, 2008 Location: NW Wash State Posts: 216	Maybe its the prepping I use the RCBS electric case prepping machine that has 5 rotating stations. One for deburring outside and one for deburring the inside. I have noticed that this will leave more of and "edge" on the case then if I do it by hand. This is only on the very edge of the case neck. Could this b causing the splits?