View Single Post
Old August 18, 2012, 09:49 AM   #8
LOUD
Senior Member
 
Join Date: May 29, 2010
Location: Virginia
Posts: 236
think Ill try spot annealing ,anybody got any good tips on the process? Besides if I go with a stonger bit Ill still have to tap it so I think softening the steel just a little Is the answer. I have some experience as a band saw sawfiler so I understand the process of annealing but have never tried anything but welds in bandsaws. Again any advice was and is appreciated.....................LOUD
LOUD is offline  
 
Page generated in 0.02790 seconds with 8 queries