Thread: M1a scope mount
View Single Post
Old December 23, 2011, 10:52 PM   #13
misterE
Senior Member
 
Join Date: March 3, 2009
Location: Benton, Arkansas
Posts: 187
Ok, got scope mounted! That sadlak mount seems to be a brute. Ran into 2 issues, but other than that it was pretty simple. 1 st, I believe I over tightened the front post set screw which was evident by looking through the irons; it looked like the mount was running up hill. Hope I didn't screw anything up there. I backed it out and carefully followed instructions on tightening, and it looks perfect.
The only other issue is that it appears that the mount is 1/16 inch out of alignment to the left. Have any of y'all run into this? Are there some adjustable rings I should get to move the scope over? I've never had to mess with shimming a scope so I'm new to all that.
misterE is offline  
 
Page generated in 0.03666 seconds with 8 queries