Thread: Range report.
View Single Post
Old January 19, 2019, 09:56 PM   #17
kilotanker22
Senior Member
 
Join Date: October 14, 2012
Location: North Central, PA
Posts: 1,011
The only thing changed from factory settings is the trigger. I kept the factory trigger, but adjusted the Take up, over travel and clipped 1.5 coils off of the spring. Then ground the spring end flat again.

Trigger breaks at 2.5 pounds. Clean, no take up. And try as I might. I can not get the sear to fall without pulling the trigger.

The Stock trigger in the TC Venture is actually quite serviceable.

Last edited by kilotanker22; January 19, 2019 at 09:57 PM. Reason: Spelling
kilotanker22 is offline  
 
Page generated in 0.03171 seconds with 8 queries